A QUICK NOTE ON STENCILS
In Each Etch-O-Matic
Kit There Is A Package Of Stencils. They Are Prepared By Using A Typewriter
Or Dot Matrix Printer.
This Is Quick,And Easy And You Can Do It Yourself.
The Marks Will Look
Just Like You Typed In Black Letters On Your Tools.
If That Is Good Enough, Then Go This Route.
MAKING
DURA-FILM STENCILS
Here is How You Make Your Dura-Film
Stencils In About 3 Minutes.
(NOTE: We Are Using Large Type So It Will Photograph Easily.)
First Make Your Copy On Your Computer. Here Is A Simple A B C Made
Large
To Show In The Photo. You Can Make Any Line Drawing, Logo,
Trademark
or Simple Message You Wish. There Is Not Much Limit Except
Photos Are
Difficult And Very Thin Lines Are Hard To Mark.
Next Print Out Your Copy On A Transparency (Which Comes In The Kit)
And Place The Transparency Copy On A Piece Of Unexposed Dura-Film
Stencil (Which Comes In The Kit) And Finally Place A Glass Plate On Top.
Next Place Tray In The 440 Dura-Film Stencil Maker And Turn On
Exposure Unit For About 3 Minutes.
Next Remove Stencil And Develop For 30 Seconds To A Minute.
Stencil Is Then Ready To Use To Mark Anything Metal.
Here We Are Marking A Saw Blade Since It Is Large Enough To
Make A Good
Photo. You Simply Lay The Stencil On The Blade, Wet The Etch-O-Matic
Pad
(On Bottom) With Electrolyte, Then Place The Etch-O-Matic On The Stencil,
Ground
For A Few Seconds And Then Remove And Your Blade Is Permanently Marked.
| ||||||||||
